TAP156M010SCS Equivalent & Substitute Parts

Part Overview

The TAP156M010SCS is a 15 µF conformal coated tantalum capacitor rated at 10 V with radial through-hole mounting. Manufactured by KYOCERA AVX, this component is part of the TAP series and maintains active product status. Alternative models may be required due to inventory constraints, design optimization for tighter tolerances, or application-specific performance requirements.

Substiute Parts

TAP156M010SCS

KYOCERA AVXIn Stock: 928TAP156M010SCS Datasheet

Current PartRFQ

TAP156K010SCS

KYOCERA AVXIn Stock: 5107TAP156K010SCS Datasheet

UpgradeRFQ

Key Parameters

Substitute Part Grouping Explanation

Substitution eligibility for the TAP156M010SCS is determined by the following critical parameters:

• Capacitance Value: Must be 15 µF (no deviation permitted)
• Voltage Rating: Must be 10 V or higher (equal or greater)
• Mounting Type: Must be Through Hole Radial
• Package Dimensions: Must match 0.197" Dia (5.00mm), 0.354" Height (9.00mm), 0.098" Lead Spacing (2.50mm)
• Type: Must be Conformal Coated Tantalum
• ESR: Must be 3.7 Ohm
• Operating Temperature Range: Must support -55°C to 125°C
• Compliance: Must maintain ROHS3 compliance

The TAP156K010SCS qualifies as a direct substitute based on these parameters. The primary difference is tolerance specification: TAP156K010SCS offers ±10% tolerance compared to the ±20% tolerance of the main part, representing an upgrade in precision while maintaining all other electrical and mechanical specifications.

Parameter Comparison

Engineering Selection Recommendations

Both TAP156M010SCS and TAP156K010SCS are active products manufactured by KYOCERA AVX and maintain full ROHS3 compliance. Selection between these parts should be based on tolerance requirements for the specific application:

• TAP156M010SCS: Suitable for applications where ±20% capacitance tolerance is acceptable and cost optimization is prioritized.
• TAP156K010SCS: Appropriate for applications requiring tighter capacitance tolerance control at ±10%, offering improved precision while maintaining identical electrical performance and physical form factor.

Both parts are functionally interchangeable from a circuit board layout perspective, as they share identical dimensions, lead spacing, and mounting characteristics. The choice between them depends solely on the tolerance specification required by the circuit design.

Frequently Asked Questions (FAQ)

Q: Can TAP156K010SCS replace TAP156M010SCS in existing designs?

A: Yes. The TAP156K010SCS is a direct substitute with identical physical dimensions, voltage rating, capacitance value, ESR, and operating temperature range. The only difference is the tighter ±10% tolerance specification, which represents an upgrade in precision.

Q: What is the primary difference between these two parts?

A: The tolerance specification differs. TAP156M010SCS has ±20% tolerance, while TAP156K010SCS has ±10% tolerance. All other electrical and mechanical parameters are identical.

Q: Are the physical packages identical?

A: Yes. Both parts use the same radial through-hole package with 0.197" diameter (5.00mm), 0.354" maximum seated height (9.00mm), and 0.098" lead spacing (2.50mm).

Q: Do both parts meet the same compliance standards?

A: Yes. Both TAP156M010SCS and TAP156K010SCS are ROHS3 compliant and REACH unaffected.

Q: Can I use TAP156M010SCS as a substitute for TAP156K010SCS?

A: No. While TAP156M010SCS shares the same physical form factor and electrical characteristics, its ±20% tolerance is wider than the ±10% tolerance of TAP156K010SCS. Applications requiring ±10% tolerance cannot use the ±20% tolerance part.