RLR05C4701GSRSL Equivalent & Substitute Parts

Part Overview

The RLR05C4701GSRSL is a 4.7 kOhms ±2% 0.125W (1/8W) through-hole resistor manufactured by Vishay Dale. This axial metal film resistor is designed for military applications with moisture resistance and weldable terminations, conforming to MIL-PRF-39017/05 specifications. The part is currently active in production with 812 units in stock. Substitute parts are identified when packaging format differs while all critical electrical and mechanical parameters remain identical.

Substiute Parts

RLR05C4701GSRSL

Vishay DaleIn Stock: 918RLR05C4701GSRSL Datasheet

Current PartRFQ

RLR05C4701GSRE6

Vishay DaleIn Stock: 1622RLR05C4701GSRE6 Datasheet

Parametric EquivalentRFQ

Key Parameters

Substitute Part Grouping Explanation

Substitution eligibility for the RLR05C4701GSRSL is determined by strict equivalence across all electrical and mechanical parameters. The primary differentiator between the main part and its substitute is the packaging format: the main part is supplied in Tape & Reel (TR) configuration, while the substitute is supplied in Cut Tape (CT) configuration. Both formats deliver identical components with no variation in resistance value, tolerance, power rating, composition, temperature coefficient, operating temperature range, physical dimensions, military series designation, or failure rate classification. The substitution is valid because packaging format does not affect component performance or electrical characteristics.

Parameter Comparison

Engineering Selection Recommendations

Both RLR05C4701GSRSL and RLR05C4701GSRE6 are active production parts from Vishay Dale with identical electrical and mechanical specifications. Selection between these parts should be based on packaging requirements and inventory availability. The Tape & Reel format (RLR05C4701GSRSL) is suitable for automated assembly processes, while the Cut Tape format (RLR05C4701GSRE6) accommodates manual assembly or lower-volume applications. Both parts maintain RoHS non-compliance status, REACH affected classification, and EAR99 export control designation. The substitute part offers higher inventory availability at 1530 units compared to 812 units for the main part.

Frequently Asked Questions (FAQ)

Q: Can RLR05C4701GSRE6 be used as a direct replacement for RLR05C4701GSRSL?

A: Yes. Both parts are electrically and mechanically identical. The only difference is packaging format: Tape & Reel versus Cut Tape. This distinction does not affect component performance or electrical characteristics.

Q: What is the difference between Tape & Reel and Cut Tape packaging?

A: Tape & Reel packaging supplies components on continuous carrier tape wound on a reel, optimized for automated pick-and-place assembly. Cut Tape packaging supplies the same components on shorter tape segments, suitable for manual assembly or lower-volume production runs.

Q: Are the physical dimensions identical between both parts?

A: Yes. Both parts measure 0.066" diameter by 0.150" length (1.68mm x 3.81mm). They are mechanically interchangeable in any circuit board layout or assembly fixture designed for axial resistors of this size.

Q: Do both parts meet the same military specifications?

A: Yes. Both parts conform to MIL-PRF-39017/05 and are designated as part of the RLR05 military series. Both maintain identical failure rate classification of S (0.001%).

Q: What compliance certifications apply to both parts?

A: Both parts are RoHS non-compliant, REACH affected, and classified under EAR99 export control. Both carry identical regulatory and compliance status.