PV10M-30 Equivalent & Substitute Parts

Part Overview

The PV10M-30 is a solar ferrule rated for 10 x 38mm dimensions with 30 ampere capacity and 10 kilovolt rating, manufactured by Eaton - Bussmann Electrical Division. This component is classified as obsolete, making identification of suitable substitutes essential for system maintenance and component replacement in photovoltaic installations. The part is RoHS compliant and carries MSL Level 1 (unlimited moisture sensitivity rating).

Substiute Parts

PV10M-30

Eaton - Bussmann Electrical DivisionIn Stock: 821PV10M-30 Datasheet

Current PartRFQ

PV-32A14F

Eaton - Bussmann Electrical DivisionIn Stock: 723PV-32A14F Datasheet

MFR RecommendedRFQ

Key Parameters

Substitute Part Grouping Explanation

Substitution for the PV10M-30 is based on the following electrical and mechanical parameters:

• Current Rating: 30-32 amperes (allowing for standard rating increments in fuse design)
• Voltage Rating: 1000V DC minimum (solar photovoltaic applications)
• Physical Form Factor: Ferrule-type construction compatible with 10 x 38mm mounting
• Compliance: RoHS compliant status maintained
• Manufacturer: Eaton - Bussmann Electrical Division (same manufacturer ensures design compatibility)

The substitute part PV-32A14F meets these criteria as an active, currently manufactured alternative within the same product family.

Parameter Comparison

Engineering Selection Recommendations

The PV-32A14F serves as the manufacturer-recommended substitute for the obsolete PV10M-30. Both components maintain RoHS compliance and EAR99 export classification. The substitute part is currently in active production status, ensuring availability for replacement applications. The 32-ampere rating of the substitute represents a standard increment above the original 30-ampere specification, consistent with fuse design practices. Both components are manufactured by Eaton - Bussmann Electrical Division, ensuring design compatibility within photovoltaic protection circuits.

Frequently Asked Questions (FAQ)

Q: Why is the PV-32A14F rated at 32 amperes when the original part is 30 amperes?

A: The 32-ampere rating represents the nearest standard fuse rating increment. In photovoltaic applications, this 2-ampere increase falls within acceptable design margins for circuit protection and is the manufacturer-designated substitute.

Q: Are both parts compatible with the same mounting footprint?

A: Both parts are ferrule-type components designed for solar applications by the same manufacturer. Physical compatibility should be verified against your specific circuit board or mounting assembly specifications.

Q: What is the significance of the voltage rating difference (10 kV vs. 1000V DC)?

A: The 1000V DC rating of the substitute is appropriate for standard photovoltaic system voltages. The original 10 kV rating indicates the PV10M-30 was designed for higher-voltage applications. Verify that 1000V DC meets your system requirements.

Q: Can I use the PV-32A14F as a direct replacement without circuit modifications?

A: Both components are RoHS compliant and manufactured by Eaton - Bussmann Electrical Division. Verify current and voltage ratings match your circuit requirements before installation.

Q: What does the "Bulk" packaging designation mean for the PV-32A14F?

A: Bulk packaging indicates the substitute part is supplied in standard industrial quantities rather than custom packaging, typical for active production components.