FGA.1B.306.CLAD52 Equivalent & Substitute Parts

Part Overview

The FGA.1B.306.CLAD52 is a 6-position circular connector plug with male pins and solder cup termination, manufactured by LEMO. This connector is designed for applications requiring shielded, push-pull fastening with gold-plated mating contacts and operates across an extended temperature range of -55°C to 250°C. The product is active and in stock with 922 units available. Substitute parts are identified to provide alternative sourcing options when the primary part is unavailable or when design flexibility permits component interchange based on equivalent electrical and mechanical specifications.

Substiute Parts

FGA.1B.306.CLAD52

LEMOIn Stock: 964FGA.1B.306.CLAD52 Datasheet

Current PartRFQ

S11LAC-P06MFG0-5200

ODUIn Stock: 961S11LAC-P06MFG0-5200 Datasheet

SimilarRFQ

Key Parameters

Substitute Part Grouping Explanation

The substitute part S11LAC-P06MFG0-5200 (ODU MINI-SNAP® L series) qualifies as an equivalent based on the following matching parameters:

• 6-position connector configuration
• Male pin plug connector type
• Solder cup termination method
• Push-pull fastening mechanism
• Shielded design with backshell
• Gold-plated mating contacts
• Brass contact material with chrome plating
• PEEK insert material
• IP50 ingress protection rating
• ROHS3 compliance
• MSL 1 (Unlimited) moisture sensitivity level
• Identical HTSUS and ECCN classifications

The substitute part maintains functional and mechanical compatibility within the scope of the provided specifications.

Parameter Comparison

Engineering Selection Recommendations

Both the FGA.1B.306.CLAD52 and S11LAC-P06MFG0-5200 are active products with ROHS3 compliance and REACH unaffected status, meeting current regulatory requirements. The LEMO part supports an extended operating temperature range of -55°C to 250°C, while the ODU substitute operates within -40°C to 120°C. The ODU part provides a marginally higher current rating of 7.5A compared to 7A for the LEMO part. Selection between these parts should be based on specific application temperature requirements and thermal operating conditions. Both parts are available in bulk packaging with substantial inventory levels.

Frequently Asked Questions (FAQ)

Q: Can S11LAC-P06MFG0-5200 be used as a direct replacement for FGA.1B.306.CLAD52?

A: The ODU part is functionally equivalent for applications operating within the -40°C to 120°C temperature range. Applications requiring operation below -40°C or above 120°C must use the LEMO part to maintain specification compliance.

Q: What are the critical matching parameters for substitution?

A: The 6-position configuration, male pin plug type, solder cup termination, push-pull fastening, shielded design, gold-plated contacts, and IP50 protection rating are the primary parameters determining substitution eligibility.

Q: Are there differences in shell finish between these parts?

A: The LEMO part features chrome plating on brass, while the ODU part uses chrome over nickel plating on brass. Both finishes provide equivalent corrosion protection within their respective operating temperature ranges.

Q: Do both parts meet the same regulatory standards?

A: Both parts are ROHS3 compliant, REACH unaffected, and share identical ECCN (EAR99) and HTSUS (8536.69.4020) classifications.

Q: What is the cable opening specification for each part?

A: The LEMO part accommodates cable diameters of 0.165" to 0.205" (4.20mm to 5.20mm). The ODU part accommodates 0.157" to 0.205" (4.00mm to 5.20mm), providing a slightly wider lower tolerance range.