ELM 2-590

Part Overview

The ELM 2-590 is a T1 LED standoff manufactured by Bivar Inc., constructed from black PVC material with a length of 0.590" (14.99mm). This component is classified as an active product and is ROHS3 compliant. Alternative models may be required due to availability constraints, specific application length requirements, or inventory optimization.

Substiute Parts

ELM 2-590

Bivar Inc.In Stock: 849ELM 2-590 Datasheet

Current PartRFQ

ELM 4-600

Bivar Inc.In Stock: 1069ELM 4-600 Datasheet

Parametric EquivalentRFQ

Key Parameters

Substitute Part Grouping Explanation

Substitution of the ELM 2-590 is permissible with the ELM 4-600 based on the following parameter alignment:

• LED Type: Both parts use T1 LED specifications
• Material: Both utilize black PVC construction
• RoHS Compliance: Both meet ROHS3 compliance standards
• Moisture Sensitivity Level: Both are rated at MSL 1 (Unlimited)
• Manufacturer: Both are produced by Bivar Inc.
• Packaging: Both are supplied in bag packaging

The primary dimensional difference is the length specification: ELM 2-590 measures 0.590" (14.99mm) while ELM 4-600 measures 0.600" (15.24mm), representing a 0.010" (0.25mm) variation.

Parameter Comparison

Engineering Selection Recommendations

Both ELM 2-590 and ELM 4-600 maintain active product status and ROHS3 compliance. Selection between these parts should be based on the specific length requirement of the application: 0.590" (14.99mm) for ELM 2-590 or 0.600" (15.24mm) for ELM 4-600. The 0.010" dimensional variance must be evaluated against circuit board layout and mechanical assembly constraints.

Frequently Asked Questions (FAQ)

Q: What is the primary difference between ELM 2-590 and ELM 4-600? A: The primary difference is the length specification. ELM 2-590 is 0.590" (14.99mm), while ELM 4-600 is 0.600" (15.24mm).

Q: Can ELM 4-600 be used as a direct substitute for ELM 2-590? A: ELM 4-600 shares identical LED type, material, and compliance specifications. Substitution is dependent on whether the 0.010" (0.25mm) additional length accommodates your mechanical design constraints.

Q: Are both parts supplied in the same packaging format? A: Yes, both ELM 2-590 and ELM 4-600 are supplied in bag packaging.

Q: Do both parts meet the same environmental and compliance standards? A: Yes, both parts are ROHS3 compliant and rated at MSL 1 (Unlimited) for moisture sensitivity, indicating equivalent handling and storage requirements.

Q: Which part should be selected if the original design specifies ELM 2-590? A: ELM 2-590 should be maintained unless application documentation confirms that the 0.010" increased length of ELM 4-600 is acceptable within mechanical assembly tolerances and PCB layout constraints.