DPL06UT Equivalent & Substitute Parts

Part Overview

The DPL06UT is a 6-position DIP switch manufactured by APEM Inc., featuring a piano actuator with SPST circuit configuration rated for 50mA at 24VDC. This component is classified as obsolete, necessitating identification of functionally equivalent alternatives for ongoing design support and procurement continuity. The switch is designed for through-hole, right-angle mounting with PC pin termination and includes epoxy sealed terminals with tape seal protection.

Substiute Parts

DPL06UT

APEM Inc.In Stock: 821DPL06UT Datasheet

Current PartRFQ

NDPL-06T-V

APEM Inc.In Stock: 772NDPL-06T-V Datasheet

SimilarRFQ

Key Parameters

Substitute Part Grouping Explanation

Substitution eligibility for the DPL06UT is determined by the following critical parameters:

• Circuit Configuration: Must be SPST to maintain functional equivalence
• Number of Positions: Must be 6-position to match pinout and board layout compatibility
• Voltage Rating: Must support 24VDC operation
• Actuator Type: Must be piano actuator with raised level for mechanical compatibility
• Mounting Type: Must be through-hole, right-angle to ensure PCB footprint compatibility
• Pitch: Must maintain 0.100" (2.54mm) spacing for board layout alignment
• Contact Finish: Gold finish provides equivalent electrical performance and reliability

The NDPL-06T-V meets all critical substitution criteria. The primary difference is the current rating: the substitute part is rated for 25mA versus the original 50mA. This represents a derating and is acceptable for applications where the circuit current requirement does not exceed 25mA.

Parameter Comparison

Engineering Selection Recommendations

The NDPL-06T-V is the active production equivalent for the obsolete DPL06UT. Both components maintain ROHS3 compliance and REACH unaffected status, ensuring regulatory alignment for new designs and legacy system updates.

Selection of the NDPL-06T-V requires confirmation that circuit current requirements do not exceed 25mA. The substitute part provides identical mechanical footprint, mounting configuration, and electrical interface characteristics. The active product status of the NDPL-06T-V ensures long-term availability and supply chain stability compared to the obsolete DPL06UT.

Frequently Asked Questions (FAQ)

Q: Can the NDPL-06T-V directly replace the DPL06UT on existing PCBs?

A: Yes. Both components share identical pitch (0.100"), height above board (0.402"), mounting type (through-hole, right-angle), and termination style (PC pin). No PCB layout modifications are required.

Q: What is the primary difference between these two parts?

A: The current rating differs: DPL06UT is rated for 50mA, while NDPL-06T-V is rated for 25mA. All other electrical and mechanical parameters are equivalent.

Q: Is the NDPL-06T-V suitable for my application if my circuit draws 30mA?

A: No. The NDPL-06T-V current rating of 25mA would be exceeded. The original DPL06UT specification of 50mA is required for this application.

Q: Are there compliance differences between the two parts?

A: No. Both parts are ROHS3 compliant, REACH unaffected, and carry identical moisture sensitivity level (MSL 1 - Unlimited).

Q: Why is the DPL06UT obsolete?

A: The DPL06UT has been discontinued by APEM Inc. The NDPL-06T-V represents the active production alternative within the APEM DIP switch portfolio.

Q: What is the mechanical life difference?

A: The DPL06UT specifies 5,000 mechanical cycles, while the NDPL-06T-V does not provide this specification. Both parts specify 2,000 electrical cycles.