DPL06 Equivalent & Substitute Parts

Part Overview

The DPL06 is a 6-position DIP switch manufactured by APEM Inc., featuring a piano actuator mechanism with SPST (Single Pole Single Throw) circuit configuration. Rated for 50mA at 24VDC, this component is designed for through-hole, right-angle mounting applications. The DPL06 is classified as obsolete, necessitating identification of active equivalent components to maintain design continuity and ensure long-term supply chain reliability.

Substiute Parts

DPL06

APEM Inc.In Stock: 984DPL06 Datasheet

Current PartRFQ

NDPL-06-V

APEM Inc.In Stock: 999NDPL-06-V Datasheet

SimilarRFQ

Key Parameters

Substitute Part Grouping Explanation

Substitution eligibility for the DPL06 is determined by the following critical parameters:

• Circuit Configuration: Must be SPST
• Number of Positions: Must be 6
• Voltage Rating: Must be 24VDC
• Actuator Type: Must be Piano with Raised level
• Mounting Type: Must be Through Hole, Right Angle
• Pitch: Must be 0.100" (2.54mm)
• Termination Style: Must be PC Pin
• Contact Finish: Must be Gold
• RoHS Compliance: Must be ROHS3 Compliant

The NDPL-06-V meets all substitution criteria. The primary difference is the current rating: the NDPL-06-V is rated for 25mA versus the DPL06's 50mA. This represents a reduction in maximum current capacity. Substitution is valid when circuit design current requirements do not exceed 25mA.

Parameter Comparison

Engineering Selection Recommendations

The NDPL-06-V is the active equivalent for the obsolete DPL06. Both components are manufactured by APEM Inc. and maintain identical mechanical and electrical interface specifications. The NDPL-06-V carries Active product status, ensuring continued availability and supply chain support.

Selection of the NDPL-06-V is appropriate when circuit design current requirements remain within the 25mA maximum rating. Both components satisfy ROHS3 compliance and REACH unaffected status, meeting regulatory requirements for industrial and commercial applications.

The DPL06 should not be specified for new designs due to obsolete status. Existing designs operating at currents exceeding 25mA require alternative component evaluation beyond the NDPL-06-V.

Frequently Asked Questions (FAQ)

Q: Can the NDPL-06-V directly replace the DPL06 in existing designs?

A: Direct replacement is valid only if circuit current requirements do not exceed 25mA. The NDPL-06-V is rated for 25mA maximum, compared to the DPL06's 50mA rating. All other electrical and mechanical parameters are identical.

Q: What is the primary reason for substitution?

A: The DPL06 is classified as obsolete. The NDPL-06-V is the active equivalent from the same manufacturer, providing continued component availability.

Q: Are there any physical differences between these components?

A: Physical dimensions are nearly identical. The DPL06 length is 0.661" (16.80mm) versus the NDPL-06-V at 0.650" (16.50mm), a difference of 0.011" (0.30mm). Both maintain the same 0.402" (10.20mm) height above board and 0.100" (2.54mm) pitch.

Q: Do both components meet the same compliance standards?

A: Yes. Both the DPL06 and NDPL-06-V are ROHS3 compliant, REACH unaffected, and carry MSL rating 1 (Unlimited). Both are classified under ECCN EAR99 and HTSUS 8536.50.9065.

Q: What is the limiting factor for substitution?

A: Current rating is the limiting factor. The NDPL-06-V's 25mA maximum rating must not be exceeded in the application circuit. If the design requires 50mA capability, alternative components must be evaluated.