C-104

Part Overview

The C-104 is a T1 LED standoff holder designed for panel clip mounting applications. This component is manufactured by Bivar Inc. and is currently in active product status. The C-104 is constructed from black nylon material with a 0.195" (4.95mm) length specification. Finding alternative models may be necessary due to inventory constraints, supply chain considerations, or specific application requirements where alternative material compositions or dimensional tolerances better suit the end-use environment.

Substiute Parts

C-104

Bivar Inc.In Stock: 1159C-104 Datasheet

Current PartRFQ

ELM 2-5MM

Bivar Inc.In Stock: 2854ELM 2-5MM Datasheet

Parametric EquivalentRFQ

Key Parameters

Substitute Part Grouping Explanation

Substitution eligibility for the C-104 is determined by the following critical parameters:

• LED Type: Must support T1 LED configuration
• Material Composition: Nylon or functionally equivalent polymer material
• Color: Black
• Length Tolerance: Within acceptable mechanical clearance limits (0.195" nominal)
• RoHS Compliance: ROHS3 Compliant
• Moisture Sensitivity: MSL 1 (Unlimited)

The ELM 2-5MM qualifies as a parametric equivalent based on these criteria. While it utilizes PVC instead of nylon and has a slightly larger length specification (0.200" vs. 0.195"), both materials are suitable for T1 LED standoff applications in panel clip configurations, and the 0.005" (0.13mm) dimensional difference falls within acceptable mechanical tolerances for this product category.

Parameter Comparison

Engineering Selection Recommendations

Both the C-104 and ELM 2-5MM are active products with ROHS3 compliance and MSL 1 ratings. Selection between these components should be based on:

C-104: Primary selection for applications where nylon material properties are specified or preferred. Nylon offers superior chemical resistance in certain industrial environments and lower moisture absorption characteristics in specific application contexts.

ELM 2-5MM: Selection when PVC material composition is acceptable or required. PVC provides alternative electrical and mechanical characteristics suitable for panel clip mounting of T1 LEDs. The slightly increased length (0.200" vs. 0.195") requires verification of mechanical clearance in the target assembly.

Both parts share equivalent compliance certifications and moisture sensitivity ratings, indicating interchangeability in applications where the material composition difference does not introduce functional constraints.

Frequently Asked Questions (FAQ)

Q: Can the ELM 2-5MM directly replace the C-104 in my application?

A: Both parts support T1 LED mounting and share identical RoHS and MSL ratings. Direct substitution is possible provided the 0.005" (0.13mm) length difference does not violate mechanical clearance requirements in your specific panel clip assembly. Verify dimensional compatibility with your mechanical drawing before implementation.

Q: What is the primary difference between these two parts?

A: The C-104 uses nylon material, while the ELM 2-5MM uses PVC. The C-104 also has a slightly shorter length specification (0.195" vs. 0.200"). Both materials are suitable for T1 LED standoff applications. Material selection depends on environmental exposure, chemical compatibility, and specific application requirements.

Q: Are both parts currently available?

A: Both the C-104 and ELM 2-5MM are active products. Inventory availability should be verified through your distributor or supplier for real-time stock status.

Q: What does ROHS3 Compliant mean for component selection?

A: ROHS3 Compliant indicates that both parts meet the Restriction of Hazardous Substances Directive requirements. This certification is relevant for applications subject to regulatory compliance in electronics manufacturing and end-product use.

Q: Is there any difference in electrical properties between nylon and PVC standoffs?

A: Both materials function as electrical insulators suitable for T1 LED applications. The electrical properties are equivalent for standard LED mounting and panel clip configurations. Material selection should focus on mechanical and environmental compatibility rather than electrical performance differences.