Equivalent & Substitute Parts for Ohmite 95J68RE

Part Overview

The Ohmite 95J68RE is a 68 Ohms ±5% 5W through-hole resistor with axial leads, featuring flame retardant coating and safety wirewound construction. This component is classified as Active product status with full RoHS compliance. Substitute parts are identified when equivalent electrical specifications and mechanical compatibility are required for procurement flexibility, inventory management, or supply chain continuity.

Substiute Parts

95J68RE

OhmiteIn Stock: 80595J68RE Datasheet

Current PartRFQ

95J68RE-B

OhmiteIn Stock: 129095J68RE-B Datasheet

Parametric EquivalentRFQ

25J68RE

OhmiteIn Stock: 122025J68RE Datasheet

SimilarRFQ

Key Parameters

Substitute Part Grouping Explanation

Substitution eligibility for the 95J68RE is determined by strict equivalence across the following parameters: resistance value (68 Ohms), tolerance (±5%), power rating (5W), composition (wirewound), package configuration (axial), temperature coefficient (±30ppm/°C), and safety features (flame retardant coating). All identified substitutes maintain identical electrical performance and mechanical compatibility within the axial through-hole form factor.

The substitute parts are grouped as follows:

Parametric Equivalent: 95J68RE-B differs only in packaging format (bulk versus box), maintaining all electrical and mechanical specifications.

Similar Equivalent: 25J68RE belongs to a different series (Series 20 versus Series 90) with minor dimensional variation (0.276" Dia x 1.016" L versus 0.264" Dia x 0.969" L) while preserving all critical electrical parameters and axial package compatibility.

Parameter Comparison

Engineering Selection Recommendations

All three parts maintain Active product status and are suitable for direct substitution based on electrical equivalence. The 95J68RE-B is the primary parametric equivalent, differing only in packaging format (bulk versus box), with no impact on component performance or board-level compatibility. Selection between 95J68RE and 95J68RE-B depends on procurement quantity requirements and packaging preferences.

The 25J68RE represents a cross-series alternative with identical electrical specifications. The dimensional difference (0.276" Dia x 1.016" L versus 0.264" Dia x 0.969" L) must be evaluated against PCB layout constraints and mechanical clearance requirements. Both the 95J68RE and 25J68RE carry RoHS Compliance certification, supporting regulatory requirements for restricted substance management.

Frequently Asked Questions (FAQ)

Q: Can 95J68RE-B be used as a direct replacement for 95J68RE?

A: Yes. The 95J68RE-B is a parametric equivalent with identical electrical and mechanical specifications. The only difference is packaging format (bulk versus box), which does not affect component performance or board-level installation.

Q: What is the primary difference between 95J68RE and 25J68RE?

A: Both parts are electrically equivalent with identical resistance, tolerance, power rating, and temperature coefficient. The 25J68RE belongs to Series 20 and has slightly larger dimensions (0.276" Dia x 1.016" L) compared to the Series 90 95J68RE (0.264" Dia x 0.969" L). Verify PCB layout compatibility before substitution.

Q: Are all substitute parts RoHS compliant?

A: The 95J68RE and 25J68RE are both RoHS Compliant. The 95J68RE-B RoHS status is not specified in available documentation.

Q: Do dimensional differences affect circuit performance?

A: No. Dimensional variations between the 95J68RE and 25J68RE do not alter electrical performance. However, physical space constraints on the PCB may limit interchangeability depending on layout design.

Q: What is the moisture sensitivity level for these parts?

A: All three parts carry Moisture Sensitivity Level 1 (Unlimited), indicating no moisture sensitivity restrictions during storage or handling.