LAPP 70450000 Hood Connector Top Entry PG16 HA10 IP65 Equivalent & Substitute Parts

Part Overview

The LAPP 70450000 is an EPIC® H-A series heavy duty connector hood designed for top entry applications with PG16 thread size and HA10 form factor. This accessory provides dust-tight and water-resistant sealing (IP65) for industrial connector assemblies operating across -40°C to 100°C. The part is currently active in production with 754 units in stock. Alternative equivalent parts may be required due to application-specific entry orientation requirements, dimensional constraints, or regional supplier availability.

Substiute Parts

70450000

LAPPIn Stock: 82770450000 Datasheet

Current PartRFQ

09200100730

HARTINGIn Stock: 119609200100730 Datasheet

SimilarRFQ

Key Parameters

Substitute Part Grouping Explanation

The HARTING 09200100730 is identified as an equivalent substitute based on the following critical parameters:

• Thread Size Match: Both parts use PG16 thread size for mechanical compatibility
• Ingress Protection Match: Both achieve IP65 rating (dust tight, water resistant)
• Housing Material Compatibility: Both utilize aluminum construction with powder coating
• Operating Temperature Overlap: Both support -40°C minimum; substitute extends to 125°C
• Heavy Duty Connector Category: Both are industrial-grade hood connectors within the same functional class
• Size Compatibility: Both use size 10A/HA10 form factors

The primary difference is entry orientation (top entry vs. bottom entry) and connector configuration (hood vs. hood-coupling), which determines application suitability based on cable routing requirements.

Parameter Comparison

Engineering Selection Recommendations

Both parts maintain active production status and are suitable for industrial heavy duty connector applications requiring IP65 environmental protection. The HARTING 09200100730 provides extended operating temperature capability to 125°C and carries ROHS3 compliance certification. Selection between these parts depends on:

• Entry Orientation Requirement: Top entry (LAPP 70450000) vs. bottom entry (HARTING 09200100730)
• Temperature Operating Envelope: Applications exceeding 100°C require the HARTING substitute
• Regulatory Compliance: ROHS3 compliance is available with the HARTING part
• Connector Configuration: Hood (LAPP) vs. hood-coupling (HARTING) determines cable-to-cable vs. single-entry applications

Frequently Asked Questions (FAQ)

Q: Can the HARTING 09200100730 directly replace the LAPP 70450000 in existing assemblies?

A: Direct replacement is possible only if the application accommodates bottom entry orientation instead of top entry. Both parts share PG16 thread size and IP65 protection, but cable routing geometry differs.

Q: What is the significance of the hood-coupling configuration in the HARTING part?

A: The hood-coupling design enables cable-to-cable connections, whereas the LAPP hood is a single-entry accessory. Application requirements determine which configuration is appropriate.

Q: Are there temperature limitations when substituting these parts?

A: The LAPP 70450000 operates to 100°C maximum. The HARTING 09200100730 extends to 125°C. Applications requiring operation above 100°C must use the HARTING substitute.

Q: Do both parts meet the same environmental protection standards?

A: Yes. Both achieve IP65 rating (dust tight, water resistant) and use aluminum construction with powder coating for corrosion resistance.

Q: What packaging considerations apply to these parts?

A: The LAPP part is supplied in standard packaging with 754 units in stock. The HARTING substitute is supplied in bulk packaging with 1124 units available.