Ohmite 41J600 Equivalent & Substitute Parts

Part Overview

The Ohmite 41J600 is a 600 Ohms ±5% 1W through-hole resistor with axial wirewound composition, part of the Ohmicone® 40 series. This component is currently active in production with 883 pieces in stock. The 41J600 is classified as RoHS non-compliant, which may necessitate identification of compliant alternatives for applications requiring regulatory adherence or supply chain continuity in restricted markets.

Substiute Parts

41J600

OhmiteIn Stock: 96441J600 Datasheet

Current PartRFQ

41J600E

OhmiteIn Stock: 91841J600E Datasheet

Parametric EquivalentRFQ

Key Parameters

Substitute Part Grouping Explanation

Substitution of the 41J600 is determined by electrical and mechanical parameter equivalence. The primary substitute identified is the 41J600E, which maintains identical electrical specifications: 600 Ohms resistance, ±5% tolerance, 1W power rating, wirewound composition, and ±20ppm/°C temperature coefficient. Both parts share the same axial package configuration and physical dimensions (0.126" Dia x 0.437" L). The critical distinction between these parts is packaging format and RoHS compliance status. The 41J600E is supplied in bulk packaging and is ROHS3 compliant, whereas the 41J600 is RoHS non-compliant. This substitution relationship is valid for applications where electrical performance and mechanical fit are the primary selection criteria.

Parameter Comparison

Engineering Selection Recommendations

The 41J600E serves as a direct parametric equivalent to the 41J600 for applications requiring identical electrical and mechanical performance. Selection between these parts should be based on regulatory and compliance requirements. The 41J600E is the appropriate choice for designs subject to RoHS3 compliance mandates or for supply chains operating in regions with RoHS restrictions. Both parts maintain active production status and are available in adequate inventory. The 41J600 remains suitable for applications without RoHS compliance constraints. Packaging format differences (standard versus bulk) may influence procurement decisions based on quantity requirements and inventory management practices.

Frequently Asked Questions (FAQ)

Q: Are the 41J600 and 41J600E electrically interchangeable? A: Yes. Both parts are rated at 600 Ohms ±5% with 1W power handling, wirewound composition, and ±20ppm/°C temperature coefficient. Electrical performance is identical.

Q: Can the 41J600E be used as a direct replacement for the 41J600 in existing designs? A: Yes, from an electrical and mechanical standpoint. The parts share identical resistance, tolerance, power rating, package type, and physical dimensions. The primary difference is RoHS compliance status and packaging format.

Q: What is the significance of the RoHS compliance difference? A: The 41J600E is ROHS3 compliant while the 41J600 is RoHS non-compliant. This distinction is critical for applications subject to RoHS regulations or for supply chains operating in markets with RoHS requirements.

Q: Do both parts fit the same PCB footprint? A: Yes. Both the 41J600 and 41J600E are axial package resistors with identical dimensions of 0.126" Dia x 0.437" L (3.20mm x 11.10mm), ensuring mechanical compatibility in the same circuit board layout.

Q: What is the difference between standard and bulk packaging? A: The 41J600 is supplied in standard packaging, while the 41J600E is supplied in bulk packaging. This affects procurement quantities and inventory management but does not impact component performance or compatibility.

Q: Are both parts currently available? A: Yes. The 41J600 has 883 pieces in stock, and the 41J600E has 856 pieces in stock, both listed as new original inventory.