Phoenix Contact 1730476 Equivalent & Substitute Parts

Part Overview

The Phoenix Contact 1730476 is a 10-position wire-to-board terminal block with horizontal mating orientation and 0.200" (5.08mm) pitch. This component belongs to the COMBICON MKDS series and is designed for applications requiring screw-based wire termination with rising cage clamp technology. The part is actively manufactured and RoHS compliant, making it suitable for industrial control, automation, and power distribution applications. Equivalent parts may be required due to supply chain constraints, design standardization across manufacturing facilities, or specific performance requirements in high-current applications.

Substiute Parts

1730476

Phoenix ContactIn Stock: 10181730476 Datasheet

Current PartRFQ

1-282857-0

TE Connectivity AMP ConnectorsIn Stock: 26651-282857-0 Datasheet

SimilarRFQ

Key Parameters

Substitute Part Grouping Explanation

The TE Connectivity AMP Connectors part number 1-282857-0 qualifies as a functional equivalent based on the following critical parameters:

• 10-position configuration with identical 0.200" (5.08mm) pitch
• Horizontal with board mating orientation
• Through-hole mounting compatibility
• Screw-based rising cage clamp wire termination with M3 thread
• 300 V voltage rating
• 12-30 AWG wire gauge acceptance
• RoHS compliance and MSL 1 rating

The substitute part maintains mechanical and electrical compatibility within the allowed parameter set for this terminal block category. Both parts support identical PCB footprints and wire termination methods.

Parameter Comparison

Engineering Selection Recommendations

Both the Phoenix Contact 1730476 and TE Connectivity 1-282857-0 are active products with RoHS compliance and MSL 1 ratings, confirming suitability for standard industrial applications. The TE Connectivity substitute provides a higher current rating of 24 A compared to the 10 A rating of the Phoenix Contact part, making it suitable for applications requiring increased current capacity within the same physical and electrical envelope. The substitute maintains identical pitch, position count, mounting method, and wire termination technology, ensuring direct PCB compatibility. Selection between these parts should be based on application current requirements and supply availability.

Frequently Asked Questions (FAQ)

Q: Can the TE Connectivity 1-282857-0 be used as a direct replacement for the Phoenix Contact 1730476?

A: Yes, within applications rated at or below 10 A. The substitute part maintains identical mechanical dimensions, pitch, mounting type, and wire termination method. Both parts accept 12-30 AWG wire and operate at 300 V.

Q: What is the primary difference between these two parts?

A: The TE Connectivity substitute has a higher current rating of 24 A versus 10 A for the Phoenix Contact part. The housing material specification differs slightly (PA66 versus PA), and the screw torque specification is higher for the TE part.

Q: Are both parts RoHS compliant?

A: Yes, both the Phoenix Contact 1730476 and TE Connectivity 1-282857-0 are RoHS compliant with MSL 1 (Unlimited) moisture sensitivity ratings.

Q: Will the PCB footprint be identical?

A: Yes, both parts share the same 10-position configuration with 0.200" (5.08mm) pitch and through-hole mounting, ensuring identical PCB footprint compatibility.

Q: Can I use the TE Connectivity part in a 10 A application?

A: Yes, the TE Connectivity part is rated for 24 A, which exceeds the 10 A requirement, making it suitable for this application.

Q: Are there any compatibility concerns with wire gauge?

A: No, both parts accept identical wire gauge specifications of 12-30 AWG.