ET01SD1AGE Toggle Switch SPDT Equivalent & Substitute Parts

Part Overview

The ET01SD1AGE is a C&K toggle switch with SPDT (Single Pole Double Throw) configuration, rated for 3A at 120V AC and 28V DC. This through-hole, right-angle mounted switch features epoxy sealed terminals and IP57 ingress protection, suitable for applications requiring dust and water resistance. The part is Active status and ROHS3 compliant.

Substitute parts are identified when equivalent electrical and mechanical parameters align with the main part's specifications, enabling direct replacement in compatible circuit designs.

Substiute Parts

ET01SD1AGE

C&KIn Stock: 1189ET01SD1AGE Datasheet

Current PartRFQ

34DWMSP11B4M6RT

Grayhill Inc.In Stock: 103334DWMSP11B4M6RT Datasheet

SimilarRFQ

34DWMSP15B4M6RT

Grayhill Inc.In Stock: 146734DWMSP15B4M6RT Datasheet

SimilarRFQ

Key Parameters

Substitute Part Grouping Explanation

Substitute parts 34DWMSP11B4M6RT and 34DWMSP15B4M6RT (both Grayhill Inc.) share the following critical parameters with ET01SD1AGE:

• SPDT circuit configuration with On-On switch function
• Through-hole, right-angle mounting orientation
• Standard round actuator with similar length (10.70mm vs. 10.16mm)
• PC pin termination style
• Non-illuminated design
• Epoxy sealed terminals
• Operating temperature range of -30°C to 85°C
• ROHS3 compliance
• EAR99 ECCN classification

Substitution is limited by differences in current rating, voltage rating, ingress protection rating, and electrical life cycle specifications.

Parameter Comparison

Engineering Selection Recommendations

ET01SD1AGE is the primary selection for applications requiring 3A current capacity at 120V AC or 28V DC with 60,000 cycle electrical life and IP57 ingress protection. All three parts maintain Active product status and ROHS3 compliance.

The Grayhill 34DWMSP series (34DWMSP11B4M6RT and 34DWMSP15B4M6RT) are functionally equivalent in circuit topology and mounting configuration but operate at reduced current (0.4VA) and voltage (20V AC/DC) ratings with enhanced IP67 ingress protection and reduced electrical life (30,000 cycles). Selection between these substitutes depends on application voltage and current requirements.

Frequently Asked Questions (FAQ)

Q: Can 34DWMSP11B4M6RT or 34DWMSP15B4M6RT replace ET01SD1AGE in all applications?

A: No. Substitution is valid only for applications operating at or below 20V AC/DC with current draw not exceeding 0.4VA. Applications requiring 120V AC or 28V DC operation must use ET01SD1AGE.

Q: What is the difference between 34DWMSP11B4M6RT and 34DWMSP15B4M6RT?

A: Both parts share identical electrical and mechanical specifications. Differences exist only in packaging (both Bulk) and inventory levels. Selection between them does not affect circuit performance.

Q: Does the actuator length difference (10.16mm vs. 10.70mm) affect mechanical compatibility?

A: Actuator length differences may affect panel cutout alignment and tactile feel. Verify mechanical fit within the target application before substitution.

Q: Are all three parts RoHS compliant?

A: Yes. ET01SD1AGE, 34DWMSP11B4M6RT, and 34DWMSP15B4M6RT are all ROHS3 compliant.

Q: What is the difference in ingress protection between ET01SD1AGE and the Grayhill substitutes?

A: ET01SD1AGE provides IP57 (dust protected, waterproof) protection. The Grayhill parts provide IP67 (dust tight, waterproof) protection, offering enhanced sealing performance.